Filter
Top Products
Turning DVD Video Camera/Recorder On and
Off
While holding down tile gray button at the right
of power switch, set tile switch according to
each recording function:
Set to "OFF":
Tile DVD video camera/
recorder will turn oft\
Set to "D":
To record still on SD
memory card
Set to "_":
To record movie on DVD
RAM or DVD R disc
Set to "1_1":
To record still on DVD
RAM disc
Note:
• Once you turn the DVD video camera/recorder on to
let it recognize the disc, you can immediately record
or play back by turning the DVD video camera/
recorder on again However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder to start
because it must recognize the disc again (see
page 158)
• It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on
• If you turn the DVD video camera/recorder on, the
ACCESS indicator wilt light or blink to show that the
DVD video camera/recorder is recognizing the disc or
card: During this time, no operation, such as
recording, can be performed
After severaI seconds, the ACCESS indicator will go
out, and operating the DVD video camera/recorder
wiIt be possible
If the ACCESS indicator does not go out, refer to
"Check 4" on page 158
PowerONstatus
During playback, set the power switch to "_"
or "1_1"when using disc, or set it to "[1_1"when
using card.
Turn the switch while holding down the gray
button at the right of switch.
ACCESS/PC
indicator
Power switch
• When the DVD video camera/recorder is turned on,
the self-diagnosis function will work and a message
may appear In this case, refer to "Trouble Messages"
on page 160 and take corrective action
• While the ACCESS/PC or CARD ACCESS indicator is
lit or blinking, do not violently open or close the LCD
monitor
44