Hitachi DZ-MV780A Camcorder Accessories User Manual


 
MACRO RECORDING
Use the macro function when recording a small object fl'om close up position: You can shoot the
suhject as close as approximately 13/16" (2 cm) fl'om tile lens surfitce, magnifying the image to fill
tile screen.
,4
/ Aint the DVD video camera/recorder at the
subject, and press the zoom lever to "W"
control side.
Note:
Zoom can be used, but the subject may not be
focused, depending on the distance to the subject In
this case, move the zoom to "W" control side to focus
The amount of light tends to be insufficient during
macro recording: If the subject image is too dark, use
additional lighting.
RECORDING SUBJECTS FOR STRONGER WIDE-ANGLE OR TELEPHOTO
EFFECT
Use the tele conversion lens or wide conversion lens with the fbllovving filter diameter and thread
pitch to record subjects for stronger telephoto or wide angle eft)ct:
Filter diameter: 34 mm for DZ GX20A or DZ MV730A: 30.5mm fbr DZ MV780A
Thread pitch: 0.5 mm
When attaching the optional DZ TL 1 tele conversion lens or DZ WL 1wide conversion lens, use the
optional step tilt ring: DZ SR3437 for DZ GX20A or DZ MV730A, DZ SR3037 fbr DZ MV780A (see
page 151).
,4 ol
/ Remove the lens hood fl_om DVD video *" Remove the cap of conversion lens, and screw
camera/recorder, and attach the step tip ring the lens into the thread of step tip ring.
over the lens.
Lens hood Conversion lens
Step-up ring
(Remove) (Attach)
Tele conversion lens: For stronger telephoto effect
Wide conversion lens: For stronger wide angle effect
Note:
Be careful not to lose the removed lens hood.
With DZ-TL1 tele-conversion lens, the focusing range
at "T" (telephoto) control side is between approx
16 feet (5 m) and infinite
When a conversion lens is attached, note that the four
corners of screen will be slightly dim if you zoom in on
a subject on the W control side (wide-angle side)
When replacing the lens, take care not to drop the
DVD video camera/recorder
Attaching the conversion lens will disable the function
of the built-in flash (for DZ-GX20A onty): Specify
'Flash: Off" (see page 76)
If a generally available filter is attached, do not attach
the removed tens hood.
57