Filter
Top Products
Note:
• If the cover of disc insertion btock is open, the
ACCESS/PC indicator will blink when an image is
displayed on the LCD monitor screen: In this case,
the DVD video camera/recorder will not turn off even if
the power switch is set to "OFF"
If the cover remains open after a while, the DVD video
camera/recorder will automatically turn off.
• Disc cannot be inserted or removed unless a charged
battery or AC adapter/charger is connected to the
DVD video camera/recorder.
• If a discharged battery is used, the disc cannot be
inserted or removed: Connect a charged battery or
AC adapter/charger to the DVD video camera/
recorder
• If there is some delay before recording starts, refer to
"Check 4" on page 158.
• If the disc is not correctly attached to the turntaNe, it
witl be difficult to close the cover: if this happens, do
not forcibly close the cover (this could cause a fault),
but re-attach the disc to the turntable correctly
• If a single-sided disc is inserted into DVD video
camera/recorder with the printed label facing the
inside, an error message will appear Remove the
disc and reinsert it with its recording side facing the
inside See "Trouble Messages" on page 160.
• When using double-sided disc
Recording is possible on both sides of double-sided
disc However, when recording or playback on one
side is finished, recording or playback will not move
automatically to the other side. Remove the disc once
from the DVD video camera/recorder, turn over the
disc and insert it again for continued use
The recording surfaces of double-sided disc are likeIy
to become dirtied or scratched: Always make sure
that there is no dirt or scratch on the recording
surface facing the pickup tens, and then use the disc
taking great care that it is not dirtied or scratched.
Use the provided disc cleaning cloth to wipe off any
dirt on disc (see page 26)
OWhen using brand-new DVD-R disc
Recognition of tile disc
will start. F r_;_iLii ..............................i
The messages on the right
will appear in sequence by
pressing the IP'/|| button
betx,veen nlessages.
When recording on this DVD video
camera/recorder:
When final message
"Format the disc now?"
appears, choose "YES"
and then press the I_./n
button. The disc will be
riot'matted.
When fiormatting is
complete, "DVD R disc,
Video mode and 16:9
II
mode cannot he changed" !_'
will appear (see page 163):
Press the I_/11 hutton to
erase the message.
Once fiormatted_ a DVD R
disc can no longer be
changed to a disc fbr PC,
even if it has not been
recorded on this DVD
video camera/recordei:
JForr_'Esr ]
Not displayed on DZ-
MV73OA
Note:
See page 91 for video mode
See page 92 for 16:9 mode
When recording data from PC (for DZ-
GX20A or DZ-MV780A only):
While the above messages are heing displayed,
press the • button_ or when message "Format
the disc now?" appears, choose "NO" and then
press the I_/|| hutton.
However, if data fl'om PC has not yet been
recorded, the disc can be made usahle on this
DVD video camera/recordei: When inserting
the disc into this DVD video camera/recorder,
the same message will appear: If you wish to use
it on this DVD video camera/recordei; choose
"YES".
Note:
Do not initialize a disc on which you wish to record data
created using the application (DVDfunSTUDIO) of PC.
46