Filter
Top Products
Even if the DVD video The DVD video camera/recorder will automatically turn on to
camera/recorder is off, recognize a disc: Closing the cover witl automatically turn the
opening the cover will DVD video camera/recorder off. 46
cause the ACCESS
indicator to blink.
During recording
Pressing the REC or Is input image copy-guarded? 27, 8I, I33,
PHOTO button wil! not Is the disc write-protected or the card locked?
start recording. I58
Recording starts but Is disc scratched or does dirt or fingerprint adhere to it?
5I
stops immediately. Clean the disc. If there is still no improvement, replace the disc.
Is some other AV device directly connected to the video/audio
input/output jack of this DVD video camera/recorder?
If the AV device is connected via several other devices, such as
80
AV selector, the video signal may not be transmitted incorrectly.
In such a case, reduce the number of devices through which the
video signal is transmitted, or connect AV device directly.
Are you attempting to record image from video game or PC?
From some video games or PCs, image cannot be recorded on 80
this DVD video camera/recorder.
LCD screen is hard to Has brightness of LCD screen been adjusted? 98
see. Stop recording and adjust the brightness.
Is the DVD video camera/recorder being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so 35, 36
that LCD screen is not exposed to direct sunlight.
Focus is not correct. Is it difficult to use auto focus with your subject? 73
Focus manually.
Does "MF" appear?
The DVD video camera/recorder is set to manual focus. Focus 72
the subject manually, or release manual focus.
Is the diopter control correctly adjusted if you are using the
viewfinder as a monitor? 36
Adjust the diopter control.
In cases other than the above, set the power switch to "OFF", and
then set it to "411","1_1" or "lt_" again. 44
An error message for Repair is only possible when the DVD video camera/recorder is
repair appears, powered by the AC adapter/charger. Remove the disc, and then
43
insert another disc: The removed disc can later be repaired by
connecting the AC adapter/charger.
Unevenness appearson Did you press the LCD monitor or the area around it?
LCD monitor screen. If the LCD monitor is pressed, some unevenness will occur.
Release your hand and leave the LCD monitor for a while:
Normal display witl be restored.
168