Filter
Top Products
46 xSeries 343 Hardware Maintenance Manual
Recovering the BIOS
It is unlikely that anything will interrupt the BIOS upgrade; however, if an interruption occurs, the
BIOS could be damaged. The following steps explain how to recover the BIOS if an upgrade fails.
Note
Because of the small amount of code available in the non-erasable boot block
area, there is no video support. You will not see anything on the screen
during the procedure. Monitor the procedure by listening to the speaker.
You must boot to DOS. The BIOS recovery diskette will not be created
correctly under the DOS window of a Windows operating system.
1. Get the BIOS update file package from IBM iBL or http://www.ibm.com/pc/support.
2. A file called “crisis.zip” is one of the files included with each xSeries 343 BIOS release file
package. Unzip the “crisis.zip” file to a directory on your hard drive.
3. Format a blank diskette (the diskette should not be a bootable DOS diskette). Insert the diskette
into the diskette drive.
4. From the DOS, run the “crisdisk.bat” file from the directory you created on your hard drive.
Follow the instructions on the screen to create the BIOS recovery diskette.
Note
The BIOS recovery diskette will not be created correctly under the DOS
window of a Windows operating system. You must boot to a DOS system to
create the BIOS recovery diskette.
5. Power off the xSeries 343 system, unplug/disconnect the power cord, and remove the chassis
panel.
6. Remove the spare jumper from pins 11-12 on jumper block 1J15 and install it on pins
9-10 (BIOS Recovery) of jumper block 1J15.
7. Insert the BIOS recovery diskette into the diskette drive.
8. Reinstall the chassis panel, plug-in/reconnect the power connection, and power-on the system.
9. The screen will remain blank while the BIOS Recovery is performed. A number of beeps will
occur during the BIOS update. The diskette drive access light will not turn off when the BIOS
recovery is completed. Allow four minutes for the BIOS recovery to complete. If a POST card
is installed in a PCI slot during the BIOS recovery, you can tell that the BIOS recovery is
complete when code “EC” is displayed. When the BIOS Recovery is complete, it is safe to
power off the system.
10. Power off the system, unplug/disconnect the power cord, and remove the chassis panel.
11. Remove the BIOS Recovery jumper from pins 9-10 and store the jumper on pins 11-12.
12. Replace the chassis panel; plug in the power cord(s), and power on the system.
13. Perform a CMOS clear following the BIOS recovery.