Filter
Top Products
72 xSeries 343 Hardware Maintenance Manual
Removing and Installing Processors
Note
If the server has been running, any installed processor and heat sink on the
processor board(s) will be hot. To avoid the possibility of a burn, allow the
unit to cool-down and be careful when removing or installing server board
components that are located near processors.
Processor must be appropriate: You may damage the server if you install
a processor that is inappropriate for your server. Make sure your server can
handle a newer, faster processor (thermal and power considerations). For
exact information about processor interchangeability, contact your customer
service representative.
Handling Static-sensitive Devices
Attention: Static electricity can damage electronic devices and your system. To avoid damage,
keep static-sensitive devices in their static-protective package until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following precautions:
• Limit your movement. Movement can cause static electricity to build up around you.
• Handle the device carefully, holding it by its edges or its frame.
• Do not touch solder joints, pins, or exposed printed circuitry.
• Do not leave the device where others can handle and possibly damage the device.
• While the device is still in its anti-static package, touch it to an unpainted metal part of the
system unit for at least two seconds. (This drains static electricity from the package and from
your body.)
• Remove the device from its package and install it directly into your system unit without setting
it down. If it is necessary to set the device down, place it in its static-protective package. Do
not place the device on your system unit cover or on a metal table.
• Take additional care when handling devices during cold weather because heating reduces
indoor humidity and increases static electricity.