Filter
Top Products
Upgrading the Chassis 85
Replacing the CD-ROM and Floppy Disk Drives
Attention: The cable can easily be damaged if not handled carefully. Refer to the installation
instructions supplied with the replacement cable.
To replace the CD-ROM and/or floppy disk drives, follow this procedure:
1. Remove the bezel.
2. Remove the three screws securing the fan bracket and remove.
3. Unplug and remove the 40 mm-fan module.
4. Disconnect the ribbon cable (A in Figure 28) from the server board.
5. Disconnect the power cable (B in Figure 28). You can access the power cable by loosening the
captive screw (C in Figure 28), and sliding the peripheral bay out an inch or two.
6. With the ribbon cable still attached to the CD-ROM drive, slide the peripheral bay out through
the front panel (D in Figure 28) and place on a clean static-free work surface.
Figure 28. Removing the Peripheral Bay from the Chassis