Filter
Top Products
83
6 Upgrading the Chassis
Replacing the Server Board
To remove the server board, follow this procedure:
1. Remove the top cover.
2. Remove the fan bracket.
3. Remove any PCI cards that may be installed in a 3.3 Volt or 5 Volt riser boards and place them
on a clean, static-free surface.
4. Unplug the PCI riser boards from the server board and place them on a clean, static-free
surface. (The upper brackets may be left attached to the riser boards.)
5. Remove the heatsink(s) and processor(s) from the server board and place them on a clean,
static-free surface.
6. Disconnect the cables attached to the board (see Figure 26) and fold them clear of the board.
OM12831
F
D
A
S
C
S
I
B
G
C
A
T
A
6
6
E
Figure 26. Removing the Server Board Cabling