Filter
Top Products
Upgrading the Hardware 71
Removing and Installing Memory
The server board supports only PC133-compliant SDRAM. Install from 128 MB to 6 GB of
registered memory, using up to six single- or double-banked DIMMs.
DIMMs must be installed in pairs in the following order: 1A-1B, 2A-2B, and 3A-3B as shown in
Figure 16. The DIMM sockets are further identified on the board’s silkscreen.
Installed DIMMs must be the same speed and must all be registered. For a list of supported
memory, call your service representative or visit the IBM Support website.
OM11790
3A
1B
2B
3B
1A
2A
Figure 16. Installing DIMMs