Filter
Top Products
Operation References
4
Operation References
Warning Indicators
If a warning indicator appears on the screen, follow the specified instructions.
The capacity of the card is full and cannot store any more
images. Delete unnecessary images (see page 19) or
replace the card with a new one (see page 9).
The card has no images recorded in the format the camera
can recognize.
The card is not inserted or is inserted improperly. Check
that it is properly inserted (see page 9).
Warning indicators Description of warning
The card is write-protected (see pages 9, 60).
The selected image cannot be read by this camera.
You cannot record any image with a file number bigger
than 999-9999. Format the card or replace it with a new
one.
NO CARD
NO IMAGES
IS FULLCARD
IS
CARD SLOT COVER
OPEN
LENS ERROR
OFF ON AGAIN/
TURN PO
W
ER
NO.MAX. IMAGE
IS SETCARD TO
READ
ONLY
PROCESS I NG WAS
STOPPED
CANNOT READ
THE DATAIMAGE
BATTERY
IS TOO LOW
TO TRANSFER THE DATA
The card slot cover is open. Close the cover.
The camera failed to process the data. Make sure the
operation procedure is correct.
Replace the batteries with new AA alkaline batteries or fully
charged Ni-MH rechargeable batteries (commercially
available) (see page 7).
You cannot set the print order to more than 999 images.
PRINT SETTING
TO IMAGES999
IS UP
If you power on the camera in any of the capture modes
and the lens barrel is obstructed (e.g. by a hand, flat
surface, lens cap), it may freeze after making contact three
times. In such case, turn the power off, remove the
obstruction then power on again.
Improper connection. Check the USB connection and
make sure the card is firmly inserted in its slot (see page 9,
57).
DISCONNECTED