Filter
Top Products
13
Basic Operations
Basic Operations
Capturing
Capturing a Still Image
in Auto Mode
In Auto Mode, the camera automatically sets
the best aperture, shutter speed, exposure
value and white balance. Light metering is set
to Center mode.
• Before you start, perform the procedures
described on pages 7 to 12 to prepare your
camera for capturing images.
1 Insert a card into the camera (see page
9).
2 Remove the lens cap.
3 Set the Mode Dial to “[”.
4 Press the Power button
until the camera turns on.
5 Press the Shutter button half-
way down to focus on the
subject.
• The camera automatically
focuses on the subject. While
focusing, you will see the status
indicator blinks green and v blinks
white in the display. When the camera
locks into focus, they stop blinking and
light up.
6 Press the Shutter button fully to
capture the image.
• The status indicator blinks while
data is being recorded on the
card, and stops blinking when
recording completes.
• When the QUICK VIEW menu item is set
to “ON”, the captured image displays on
the LCD screen for a few seconds.
• To capture another image, release the
Shutter button and make sure the status
indicator lights up, then perform steps 5
and 6.
Notes:
• Do not turn the power off while the status
indicator is blinking in step 6.
• Remove the lens cap before powering on the
camera.
005/16.5F
005/16.5F
2448
]
Fine
[
ISO 0100
Status indicator
Mode dial
Shutter button
Power button