Filter
Top Products
7
Preparation
Preparation
Inserting and Removing
the AA Batteries
Before operation, you need to insert the
supplied AA (R6 or UM/SUM-3) alkaline
batteries.
Inserting
1 Make sure that the power is off.
2 Slide the battery compartment door
release to UNLOCK.
3 Slide the door, then open it in the
direction of arrow.
4 Insert the AA batteries as shown below.
5 Close the door, then slide the battery
compartment door release to LOCK.
Removing
Perform steps 1 to 3 in “Inserting”, then
remove the batteries.
Notes:
• BEFORE REMOVING THE BATTERIES,
ALWAYS STOP OPERATIONS AND TURN THE
POWER OFF. Removing the batteries during
operation may destroy the card, rendering it
unreadable and unwritable.
• Remove the batteries from the camera if you will
not use the camera for a long period of time.
• Make sure that the battery compartment door
release is set to LOCK during operation. If it is
not, the batteries may fall out or camera
operation may fail because of poor contact
pressure.
• Do not use old and new batteries together or
batteries of different brand together.
• When the batteries are depleted, replace them
with new AA (R6 or UM/SUM-3) alkaline batteries
or fully charged Ni-MH rechargeable batteries
(commercially available).
Battery performance
The table below shows the approximate
number of recordable images when using
different types of batteries.
AA Alkaline (supplied)
Battery type
Approximate
number of images
Rechargeable Ni-MH
(1600 mAh)
100
200
Notes:
• Images taken per usage, based on standard
testing.
• Using the zoom (see page 15) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease in the actual
recording number compared to the numbers
listed above.
• The number of images you can record with
commercially available batteries may differ from
the supplied AA alkaline batteries in the table
above.
Battery compartment
door release