Filter
Top Products
3-2
Turning the camera on
If your camera is idle for the time period you set in the Camera Properties Time-
out Settings, it automatically turns off. To turn the camera on again, press the
POWER button.
Entering the Capture mode
You will use the Capture Mode to take pictures. To place the camera in the
Capture Mode:
1 Press the POWER button.
The green Ready light on the back of the
camera blinks for approximately 10 seconds
until the camera is ready to take pictures and
the Status Display on the top of the camera
turns on.
To turn the camera off, press the POWER
button again.
☞ If the camera is turned off while a picture
is being processed, the camera will finish
processing the picture before turning off.
1 Turn the Mode dial to the CAPTURE
setting.
The camera moves the lens to a point away
from the camera.
☞ You cannot take pictures without a
memory card in the camera. If you enter
the Capture mode without a memory
card, the Status LCD flashes the message
“NO CARD.”
If the camera goes into sleep mode to
conserve power, the word “CARD”
remains on the Status LCD.
Ready light