Filter
Top Products
Installation
13
3
Installation
USB External device
Connect the external device to the USB port.
(Example: External HDD or other external storage.)
Mouse
Connect the USB mouse to operate the system.
Connecting E-SATA device
You can use E-SATA storage for data back-up or recording.
E-SATA device connection
IN
OUT
VGA
HDMI
2
4
1
3
E-SATA
USB
5 V 0.5 A
LAN
DC 48 V
CAM
AUDIO
- + 1 2 3 4 G 1 2 G
IN
OUT
ALARM
RS
485
Connecting Network
You can control and monitor the system via network. With
the remote control (monitoring), you can change the system
configuration or monitor the image via network. After the
installation, check the network settings for the remote control and
monitoring work.
Network connection
IN
OUT
VGA
HDMI
2
4
1
3
E-SATA
USB
5 V 0.5 A
LAN
DC 48 V
CAM
AUDIO
- + 1 2 3 4 G 1 2 G
IN
OUT
ALARM
RS
485
Router
Broadband
Service
Router
Broadband
Service
LAN connection
Connect the LAN port to an available 10/100/1000 base-T port with
a straight ethernet cable (not supplied). The NET indicator on the
front panel will be lit.
IP Camera connection
Connect the IP camera. After the installation, check the IP camera
settings on the setup menu.
Automatic network configuration
The system can automatically obtain and configure the network
interface via DHCP.
Manually configure network
The system may be manually configured by assigning an IP address,
subnet mask, gateway and DNS.
NOTE
This unit can be supported IPv4 and IPv6 network.
Connecting IP Camera
Connect the IP Camera for Plug and connect.
NOTE
• To use IP Camera for plug and connect port, should be set to
DHCP. It will be changed to Static automatically by the system.
• When you connect a camera, you should set the administrator
ID and password of camera as below table.
ID Password
admin admin
root root
root 4321
• The IP camera must be supported ONVIF.
IP Camera connection
IN
OUT
VGA
HDMI
2
4
1
3
E-SATA
USB
5 V 0.5 A
LAN
DC 48 V
CAM
AUDIO
- + 1 2 3 4 G 1 2 G
IN
OUT
ALARM
RS
485