Filter
Top Products
Installation
25
3
Installation
When you want to change DDNS host name
If you want to change the registered host name to new one, follow
as shown below.
1. Enter a new host name in the [Host Name] option.
2. Press the [Update] button. The confirmation window will be
displayed to change your host name.
3. Click the [OK] button. When host name is properly changed, the
changed host name will be displayed in the [Registered Host]
option. If host name is not changed after updating, please check
network connection.
Network Streaming
• CH: Displays the channel number.
• Profile: Selects the profile of stream. The [Profile] option is
activated in case of IP Camera only.
NOTE
If you need to adjust the image size to send to the client, set
the stream option of the [IP Device-Profile1 or Profile2]. And
then select the proper Profile from the [Network Streaming-
Profile]. You can control the bandwidth value forward to client.
Date/Time
• Date: Select the current year, month and day.
• Time: Select the current time.
• Date Format: Select the date display format.
• Time Format: Select the time display format.
• Time Zone: Select the time zone in the area where the system is
installed.
• Daylight Saving: Mark up if you want to use the daylight saving
function.
• Daylight Saving Start: Select the Daylight Saving start time.
• Daylight Saving End: Select the Daylight Saving end time.
NTP
• NTP: Marks up, if you want to synchronize the system's date and
time with those of the time server called NTP. (Network Time
Protocol) Specify the NTP server’s name.
• Time Server: For most cases select public. The system will obtain
the average time among 5 public servers (time.nist.gov, time-a.
nist.gov, time-b.nist.gov, ntp.nasa.gov, clock.isc.org).
• Private Time Server: Enter the private time server’s IP address or
host name using the virtual keyboard.
• Sync. Interval: You can set synchronized intervals with the NTP
time server to 1 day, 1 week, 1 month and 1 hour.
• NTP Test: Select [NTP Test] to test the NTP server.
NOTE
If the NTP option is not set to this system, there can be a
gap between the system time and actual time. Using NTP is
recommended.
Controller
• IR Remote ID: Select the IR Remote ID for this unit. If you use
multi systems set the IR Remote ID for each unit.
• Remote Controller ID: Select the Remote Controller ID for this
unit. If you use multi systems, set the Remote Controller ID for
each unit. You can control the system by using the LKD1000
controller. (For more details refer to the LKD1000 owner’s
manual.)