Filter
Top Products
Installation
33
3
Installation
Sensor
Settings concerning sensor recording.
• CH: Displays the channel number.
• Prealarm: Specify the pre-event recording time. When the Event
signal is detected, the system recordes the data before the
event during the setting time.
• Postalarm: Specify the post-event recording time. When the
Event signal is detected, the system recordes the data after the
event during the setting time.
Motion
Settings concerning motion recording.
• CH: Displays the channel number.
• Prealarm: Specify the pre-event recording time. When the Event
signal is detected, the system recordes the data before the
event during the setting time.
• Postalarm: Specify the post-event recording time. When the
Event signal is detected, the system recordes the data after the
event during the setting time.
NOTE
The Prealarm recording time may shorten depending on the
setting and recording status of camera.
Event settings
Sensor
• In: Displays the number of the ALARM-IN terminal.
• Sensor Type: The sensor state can be set to either N.O. (Normally
Open) or N.C. (Normally Closed).
• Camera: Select the camera channel when the sensor event is
occurred.
• Relay Output: Select the alarm (relay) output number for the
RELAY-OUT terminal for the output alarm (relay) signal.
• Preset: Select the preset number. When the input is activated,
the camera moves to the selected preset position and the
picture of the camera in that position appears on the monitor.
Notification
Marks up when you want to activate the selected option. If the
selected notification option is activated, the device will notify the
user about the information of selected option by E-mail.
• Sensor On: Sends an e-mail when a sensor has occurred.
• Motion Detection: Sends an e-mail when a motion detection
has occurred.
• Admin Password Changed: Sends an e-mail when the
administrator password has been changed.
• Power On/Off: Sends an e-mail when power is on or off.
• Disk Full: Sends an e-mail when the HDD has fully recorded.