Filter
Top Products
34
Installation
3
Installation
Mail
• Notification: Mark up to be notified the unit's operating
information according to notification settings by e-mail.
• SMTP Server: Enter the SMTP Server address.
If notification option is not mark up and the SMTP server option
is empty, the SMTP Port, User Name, Password and TLS options
cannot be set.
• SMTP Port: Enter the SMTP Port Number. Typically the port used
for SMTP is 25. However in some cases it is better to change this
port number for added flexibility or security. You can edit this
port between 1 and 65535.
• User Name: Enter the user name.
• Password: Enter the password.
• TLS: Mark up if you use the TLS (Transport Layer Security)
function.
• Mail Address (1 to 3): Enter the mail address.
You can input up to 3 e-mail addresses.
• Sender: Enter the sender.
• JPEG Attachment: Click the check box to send a mail which
want to attach a JPEG file.
• E-mail Test: Select [E-mail Test] to test sending an e-mail.
NOTE
• The SMTP server, SMTP port no., user name or password
settings are optional. The system can send e-mail directly
without the use of an SMTP server or MTA (message transfer
agent). In certain cases all e-mail should be forwarded to
a specific SMTP server. Specify the server host name or IP
address in such a case. For more detail on SMTP setup, ask
your network administrator and/or mail service provider.
• [JPEG Attachment] option is operated when event of [Sensor
In], [Motion Detection] and [Text In] is occurred.
• In case of an IP Camera, ONVIF JPEG Snapshot feature must be
supported to attach a JPEG file.
Emergency
• Notification: Mark up to be notified the emergency agent about
the unit's operating information according to your notification
settings.
• Host Name/Port: Enter the Host Name and port number of the
emergency agent program. The factory default port for this
function is 9002. However in some cases it is better to change
this port number for added flexibility or security. You can edit
this port between 1025 and 65535.
You can set up to 9 Host Name and port numbers.
SNMP
The Simple Network Management Protocol (SNMP) is an application
protocol to exchange the management information of network
devices.
• SNMP Version: Selects a SNMP version if SNMP is allowed to
access to this device.
• Port: Enter the number for SNMP port.
• Community String (V2 only): Specifies the SNMP management
community in which you want to enable this system (e.g.
lgecommunity or public).
• User (V3 only): Enter the security name for the SNMP.
• Authentication (V3 only): Select a mode for the SNMP
Authentication. (MD5 or SHA)
• Password (V3 only): Enter the password for the SNMP
Authentication.
• Privacy (V3 only): Select a privacy mode for the SNMP
Authentication. (DES or AES)
• Password (V3 only): Enter the password for the privacy mode.
• Trap IP Address: Specifies the IP address of the computer you
intend to use as your network management station and to
which SNMP traps will be sent.