Filter
Top Products
10
Chapter 4: iGuardware
4.2.1.1 Setup Wizard
“Setup Wizard” will take you through the basic configurations step by step.
1. Click to highlight the iGuard on the right that you want to configure.
2. Click on “Setup Wizard”.
First, you must enter the device password located on the serial label to enter
“Setup Wizard”; or “Launch iGuard”, or “IP Configuration” if the iGuard has a
preset password.
WARNING:
Do not lose this password. If the password is lost, you can not access the device
to make changes. If you lose this password, you’ll have to contact your reseller
for the master password.
3. Once you have entered the necessary information for “Input Device Password”
and “Administrator authentication”, iGuard “Setup Wizard” will initiate to take you
through the installation.
Fig.5 iGuard Setup Wizard