Filter
Top Products
18
Chapter 4: iGuardware
ii. Management Protocol
The administrator can determine the parameter settings when providing access
via HTTP (web) to iGuard. For security reasons, the administrator can choose to
use either an open or advanced port setting to control these access.
The default values are set to port number 80 for HTTP.
Once the HTTP port number is set to another port (other than 80), the full IP
Address must be entered in order to access the Website.
For example:
) If a value of 61 is set as the HTTP port number, then http://192.168.0.177:61
must be entered as the web address in order to access iGuard website.
Uncheck to disable this function.
4.2.1.4 Upgrade Firmware
iGuard Utility offers a convenient method to upgrade iGuard firmware.
1. Click “Upgrade Firmware” to bring up the Wizard.
Fig.15 Upgrade Firmware: Updates iGuard firmware
If you have downloaded the latest firmware to your local hard drive, check
“Upgrade the iGuard firmware with file saved on the local hard drive” and browse
to the file location.
2. Click “Next >” to check for the latest available firmware.