Filter
Top Products
17
Chapter 4: iGuardware
i. Device Password
Use this to set an access password to the individual device. Once set, the user
must enter the password to access the device. In addition, the IP Address will
not be shown on the right display panel of iGuard Utility.
Note: The default device password is set to be the same as administrator
password, which is the printed on the serial label.
Fig.14 Reset Device Password
iGuard Utility will request for the “Input Device Password” when you click either
“Setup Wizard”, “Launch iGuard” or “IP Configuration”
WARNING:
Do not lose this password. If the password is lost, you can not access the device
to make changes. If you lose this password, you’ll have to contact your reseller
for the master password.
To remove the password, you must first enter a valid “Input Device Password”,
go to “Device Password” and delete the entries, click “OK”.
Devise
Password
enabled. IP
Address
hidden.