Filter
Top Products
14
Concerning the wireless remote control
Operate the wireless remote control from positions less than 32.8 ft. (10 meters) away from the unit.
The wireless remote control ma
y not work when it is pointed from certain angles at the unit.
From a place where the wireless remote control signal light-sensing area (hereafter, “light-sensing area”) can be seen, point
the signal transmission window of the wireless remote control at the light-sensing area, and operate the buttons.
If the unit is installed near fluorescent lights,
plasma monitors or other such products or if the unit is exposed to
sunlight, the effects of the light may make it impossible for the unit to be operated using the wireless remote control.
Be sure to follo
w the steps below for installation and use.
• Take steps to ensure that the light-sensing area will not be exposed to the light from fluorescent lights, plasma monitors
or other such products or from the sun.
• Install the unit aw
ay from fluorescent lights, plasma monitors and other such products.
• Operate the wireless remote control at positions within 9.8 ft. (3 meters) from the unit.
• Use a controller that has been connected to the unit using a cable (wired connection).
For about 10 min
utes even after the batteries have been removed from the wireless remote control, the selection of
the operation to be performed (the [CAM1], [CAM2], [CAM3] or [CAM4] button which was pressed last) will remain
stored in the memory. When a longer period of time elapses, however, the selection is reset to the status established
when the [CAM1] button was pressed.
Getting the wireless remote control ready
1 Remove the battery compartment cover.
2 Insert the dry batteries.
Two size “AA” manganese dry batteries (obtained
separately) are used. Do not use any other kind of
batteries. Check which ends of the batteries are the “+”
electrodes and which ends are the “–” electrodes.
Load the batteries correctly by inserting the negative
end first.
3 Put the battery compartment cover back.
Dispose of batteries that are no longer usable together with
other incombustible garbage or in compliance with the local
ordinances.