Filter
Top Products
38
When doing the adjustment
using the controller
The same operations as those in “When performing the
operations using the accessory wireless remote control” can
be performed following the operation procedure for “Basic
menu oper
ations” (pages 40 to 42).
When the AW-RP655 is connected:
1 Press the [MENU] button.
2 Turn the jog dial (main) to display “G/L
SETTING” on the LCD panel.
3 Press the [OK] button, and display
“H PHASE”.
4 Turn the jog dial (R) and adjust it to bring
the horizontal phase into alignment.
When adjusting the horizontal phase using the
controller, press the [MODE] button or [BAR/CAM]
button to switch to “BAR” (the button’s lamp lights
and color bars are displayed), and proceed with the
adjustment. The horizontal phase cannot be adjusted
in the “CAM” (camera picture) status.
After performing the adjustment, be sure to return to
“CAM”. (The button’s lamp goes off.)
When hor
izontal phase adjustment is moved, color
phase is also moved. Adjust color phase whenever
horizontal phase adjustment is moved.
Notes
Color phase adjustment
The color phase adjustment must be performed if the
pictures are to be switched using a video switcher or other
device when the video output signals have been set as
composite or Y/C signals.
It need not be performed when the video output signals
have been set as component signals.
The camera’s color phase is aligned with the program
output (split color bar output) signals of a color special effect
device or other color tones that will serve as the reference.
(The color phase can be adjusted more accurately if a
vectorscope is used for the adjustment.)
Color bar of camera
Split line
Color bar of special
effects generator
When performing the operations using the
accessory wireless remote control
1 Press the [MODE] button.
The mode is switched to the color bar display.
2 Set to the user mode by following the
steps in “Selecting the shooting modes
(scene files)” (page 20).
At this time, keep the “Mode Set” sub-menu on the
display.
The color phase adjustment is common to all
shooting modes (scene files), but when the wireless
remote control is used to perform the adjustment, the
shooting mode must be selected. For this reason,
either select the shooting mode which will be used
subsequently or select the shooting mode again
afterward.
Halogen Mode Set
Brightness Set
Color Set
G/L, Setup Set
Other Set
Initialize
Return
Example: Halogen mode
Genlock adjustment