Filter
Top Products
56
Troubleshooting
Operation
Symptom Cause and remedial action Reference pages
No power
Has the power plug been connected securely to the AC power
outlet?
—
Has the po
wer plug been connected pr
operly?
—
If the unit is connected to the contr
oller, has it been connected
properly?
Refer to the Operating Instructions of the controller.
Installation
Instructions
P
.
29 to 31
When the unit is being operated by the wireless remote contr
ol
Also ref
er to the “Cannot operate using the wireless remote control”
item.
—
Cannot operate
(common to wireless
remote control,
controller)
Is the power on?
If the unit’
s status display lamp is off or if it has lighted up orange,
it means that the unit’s power is not being supplied.
P.16
Has the correct unit to be operated been selected?
P.18
One of the saf
e mode functions ma
y have been activated.
P.55
Have the limiter functions been set?
P
.53 to 54
W
as the setting for “Controller” (accept control from control device
selection) on the menu item changed previously?
Change the setting by following the steps on the reference page.
P.43
Cannot operate
using the wireless
remote control
Have the remote control’s batteries run down or have the batteries
been installed with their polarities reversed?
If the status displa
y lamp does not blink even when the wireless remote
control is operated near the wireless remote control signal light-sensing
area, it means that the batteries have run down. Replace the batteries.
—
Is there a fluorescent light or plasma monitor near the unit and,
if so,
is the wireless remote control signal light-sensing area exposed to
its light?
P.14
Cannot operate
using the controller
Is the unit connected to the controller properly?
Refer to the Operating Instructions of the controller.
Installation
Instructions
P
.
29 to 31
Has the controller selector s
witch been set to the correct setting?
Check the switch setting.
Refer to the Operating Instructions of the controller.
Installation
Instructions
P
.
29 to 31
It ma
y be necessary to upgrade the version of the controller so that
the controller will support the unit.
Consult with your dealer.
—
If the unit is being used in combination with the A
W-RP400 and
AW-CB400, a setting to prohibit the operation of one of these devices
may have been established.
Refer to the Operating Instructions of the controller.
—
The unit turns in the
opposite direction to
the one operated
Has the stand-alone (Desktop) installation setting been selected
correctly?
Installation
Instructions
P
.
21
When the picture has been in
verted by the automatic picture flipping
function, the unit may appear to turn in the opposite direction to the
one operated.
P.43
The re
versal setting may have been established at the controller
if the unit is connected to the controller.
Refer to the Operating Instructions of the controller.
—