Filter
Top Products
29
Preset memories
This unit enables up to 100 settings for the camera direction (panning and tilting), zoom, focus and iris to be registered in its
preset memories, and called.
However, the number of settings that can be registered and called depends on the type of wireless remote control or controller
that is used for operation.
The status as to whether the man
ual settings or auto settings are applicable is not registered for the focus and iris.
The current focus and iris values are registered.
The focus and iris values can be recalled only when the manual settings are applicable.
When performing the operations using the
accessory wireless remote control
Twelve settings (preset No.1 to No.12) can be registered and
called using the wireless remote control.
The [1] to [12
] buttons correspond to the unit’s preset
memories No.1 to No.12.
Registering the settings in the preset memories
1 Display the picture to be shot on the
monitor.
Operate the pan, tilt or zoom buttons to determine the
camera angle.
Adjust the focus and iris if they need to be adjusted.
2 While holding down the [PRESET] button,
press the button corresponding to the
preset memory number.
If a preset memory number with an already
registered setting has been selected, the existing
setting will be erased and replaced with the new one.
Calling the settings of the preset memories
1 Press the button in which the preset
memory setting has been registered.
When performing the operations
using the controller
When the AW-RP655 is connected:
Up to 50 settings can be registered and called.
The [1] to [50] buttons of [TRACING/PRESET MEMORY]
correspond to the unit’s preset memories No.1 to No.50.
Registering the settings in the preset memories
1 Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2 Set to the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3 Display the picture to be shot on the
monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus and iris if they need to be adjusted.
4 Hold down the [MEMORY] button.
The buttons among the [1] to [50] buttons of
[TRACING/PRESET MEMORY] in which settings can
be registered now start blinking in sequence.
Preset memor
y settings cannot be registered in
buttons whose lamps are off (since they contain
tracing memory settings).
5 With the [MEMORY] button still held
down, press the button of the preset
memory number in which the setting is to
be registered.