Filter
Top Products
49
Genlock/color bar setting menu
The same settings established on the genlock/color bar
setting menu are common to all the shooting modes
(halogen light mode, fluorescent light mode, daylight mode
and user mode).
(When a setting in one mode is changed, the same setting
is established in the other modes.)
G/L, Setup Set
H Phase ±0
SC Coarse 90deg
SC Fine ±0
Setup Level On
Return
1--------
2--------
3--------
4----------
5------
1 Horizontal phase adjustment
[H Phase: –206 to +49]
(Factory setting: ±0)
Using this item, the horizontal phase during genlock can
be adjusted.
2 Color phase coarse adjustment
[SC Coarse: 0deg, 45deg, 90deg, 135deg,
180deg, 225deg, 270deg, 315deg]
(Factory setting: 90deg)
Using this item, the color phase during genlock can be
adjusted coarsely. This setting takes effect only when
VBS or Y/C signals are output as the video signals.
3 Color phase fine adjustment
[SC Fine: –127 to +127]
(Factory setting: ±0)
Using this item, the color phase during genlock can be
adjusted finely. This setting takes effect only when VBS or
Y/C signals are output as the video signals.
4 Setup level selection
[Setup Level: Off (0 IRE), On (7.5 IRE)]
(Factory setting: On)
Using this item, the setup level can be selected.
5 Return to the previous menu (menu for
selecting the shooting mode) [Return]
Sharpness setting menu
(user mode only)
The sharpness setting menu is provided in the user mode
only.
Sharpness(DTL) Set
Detail On
Total Detail Level 2
V Detail Level 4
Noise Suppress 0
Return
1--------
2--------
3--------
4--------
5------
1 Detail ON/OFF selection [Detail: On, Off]
Using this item, ON or OFF is selected for detail
compensation.
When “On” is selected, the amount of the detail
compensation can be adjusted using the “Total Detail
Level” and “V Detail Level” menu items.
2 Total detail level selection
[Total Detail Level: 0 to 14, ---]
(Factory setting: 7)
Using this item, the amount of the edge enhancement in
the horizontal and vertical directions is selected.
When “Off” is selected as the detail ON/OFF selection
setting, “---” is displayed, and no selection is possible.
3 Vertical detail level selection
[V Detail Level: –7 to +7, ---]
(Factory setting: ±0)
Using this item, the amount of the edge enhancement in
the vertical direction is selected.
When “Off” is selected as the detail ON/OFF selection
setting, “---” is displayed, and no selection is possible.
4 Noise suppression [Noise Suppress: 0 to 7]
(Factory setting: 0)
Using this item, the amount of screen noise generated by
the detail can be reduced. The higher the value selected,
the greater the reduction of the noise. However, if too high
a value is selected, the sharpness of detailed subjects
will be reduced.
5 Return to the previous menu (menu for
selecting the shooting mode) [Return]
Setting the menu items