Filter
Top Products
13
VQT2M75
Quick Guide
∫ Charging the battery
1 Connect the AC cable to the AC adaptor
and the AC outlet.
2 Insert the battery into the AC adaptor by
aligning the arrows.
∫ Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
≥ Check that the access lamp has gone off.
2) Open the SD card/terminal cover and
insert (remove) the SD card into (from)
the card slot.
≥ Face the label side B in the direction
shown in the illustration and press it
straight in as far as it will go.
≥ Press the center of the SD card and then
pull it straight out.
3) Securely close the SD card/terminal
cover.
≥ Securely close it until it clicks.
∫ Turning the unit on/off
Turning the power on and off with the
power button
Press the power button to turn on the power.
A The status indicator lights.
≥ To turn off the power, hold down the power
button until the status indicator goes off.
Turning the power on and off with the
LCD monitor/viewfinder
Opening the LCD monitor or extending the
viewfinder turns on the power. Closing the
LCD monitor/viewfinder turns off the power.
To turn on the power
A The status indicator lights on.
Access lamp [ACCESS] A
≥ When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging completed
HDC-TM700&HS700P&PC-VQT2M75_mst.book 13 ページ ２０１０年２月２３日 火曜日 午前１０時３４分