Panasonic HDC-HS700P/PC Camcorder User Manual


 
55
VQT2M75
Advanced
Recording
(Advanced)
1
Zoom in/out function
The maximum optical zoom ratio is 12k.
The default setting of the [ZOOM MODE] is [i.Zoom 18k]. It can be extended to a maximum
of 18k during Motion Picture Recording Mode. (l 66)
¬ Change the mode to or .
Zoom operation can be done using the multi
manual ring.
Zoom by rotating the ring.
The zoom speed varies depending on the
speed to rotate the ring.
If the number of the recording pixels is set to
anything other than the maximum number of
recording pixels in Still Picture Recording
Mode, the still picture can be recorded with a
zoom ratio of a maximum of 25k without
degrading the picture quality.
Extra optical zoom ratio varies depending
on the setting of [PICTURE SIZE] and
[ASPECT RATIO]. (l 78, 79)
Extra optical zoom mechanism
When you set the picture size to , the
maximum area is cropped to the center
area, allowing a picture with a higher
zoom effect.
If you take your finger off the zoom lever during zoom operation, the operation sound may
be recorded. When returning the zoom lever to the original position, move it quietly.
When the zoom magnification is 12
k
, the subjects are focused at about 1.2 m (3.9 feet) or more.
When the zoom magnification is 1k, this unit can focus on a subject approx. 4 cm (1.6q)
away from the lens.
The zoom speed does not vary when operating with the adjust zoom buttons and the
remote control.
6
W
T
6
W
T
TW
VOL
WT
VOL
Zoom lever/Adjust zoom buttons
T side:
Close-up recording (zoom in)
W side:
Wide-angle recording (zoom out)
The zoom speed varies depending on the
range over which the zoom lever is moved.
The adjust zoom buttons are useful for
making fine adjustments to the zoom
magnification.
Ring zoom
A
B
A side:
Close-up recording
(zoom in)
B side:
Wide-angle
recording (zoom out)
Extra Optical Zoom
0.3
M
12.2
M
0.3
M
HDC-TM700&HS700P&PC-VQT2M75_mst.book 55 ページ 2010年2月23日 火曜日 午前10時34分