Filter
Top Products
73
VQT2M75
This will reduce the wind noise coming into the built-in microphones while maintaining the
realism.
≥ Change the mode to .
≥ Switch to Manual Mode. (l 82)
≥ When switching to Intelligent Auto Mode, [
WIND NOISE CANCELER
] is set to [ON], and the
setting cannot be changed.
≥ You may not see the full effect depending on the recording conditions.
≥ If wind sound cannot be reduced with the Wind noise canceler function alone, set [BASS
SETTING] to [LOWCUT]. (l 75)
Recording setting of the built-in microphone can be adjusted.
≥ Change the mode to .
≥ Switch to Manual Mode. (l 82)
≥ If you wish to record higher quality sound and maintain realism even when zooming in, for
instance, when recording a music recital, we recommend setting [MIC SETUP] to
[SURROUND].
[WIND NOISE CANCELER]
: [RECORD SETUP] # [WIND NOISE CANCELER] # [ON]
[MIC SETUP]
: [RECORD SETUP] # [MIC SETUP] # desired setting
[SURROUND]: Sound is recorded with 5.1 ch surround microphone.
[ZOOM MIC]:
Directivity of the microphone is synchronized with the zoom
operation. Sounds near the front of the unit are recorded more
clearly if you zoom in (close-up) and surrounding sounds are
recorded more realistically if you zoom out (wide angle).
[FOCUS MIC]: Directivity of the center is enhanced for recording audio
near the front of the unit more clearly.
[STEREO MIC]: Sound from two directions is recorded in 2 ch by forward-
facing stereo microphones.
HDC-TM700&HS700P&PC-VQT2M75_mst.book 73 ページ ２０１０年２月２３日 火曜日 午前１０時３４分