Filter
Top Products
48
VQT2M75
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened
or the viewfinder is extended.
≥ When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥ Start time will not be shortened if there is no SD card inserted.
Start time will be shortened if the [Built-inMemory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
Start time will be shortened if the [HDD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to or .
1Set [QUICK START] to [ON].
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or .
The status indicator A flashes green and the unit
goes into Quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the
unit is put into recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥ Time for Quick start will be more than 0.6 seconds slower when the Digital cinema is used.
≥ Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 47) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
Please refer to page 53.
[QUICK START]
[OFF]/[ON]
[REMOTE CONTROL]
[OFF]/[ON]
HDC-TM700&HS700P&PC-VQT2M75_mst.book 48 ページ ２０１０年２月２３日 火曜日 午前１０時３４分