Filter
Top Products
32
2
Quick Start
Quick Start
Taking Still Pictures
The standard procedure for taking still pictures is described below. The
flash fires automatically depending on the light conditions.
1 Press the power switch.
The camera turns on.
2 Set the mode dial to R.
3 Check the image on the LCD
monitor.
The focus frame in the middle of the LCD
monitor indicates the zone of automatic
focusing.
You can change the captured area by pressing the Zoom/w/x button
to the right or left.
x : enlarges the subject
w : enlarges the area captured by the camera
You can check the captured area by looking through the viewfinder.
4 Press the shutter release button halfway.
The focus frame turns green if the subject is in focus.
The image in the viewfinder always appears with a 4:3 aspect ratio
regardless of the aspect ratio setting of the image. Use the LCD
monitor when taking pictures with the aspect ratio set to 3:2.
Shutter release
button
Mode dial
Zoom/w/x button
i button
38
38
14
14
:25
:25
14:25
09/25/2004
09/25/2004
09/25/2004
Focus frame