Filter
Top Products
171
5
Using the Flash
Set the camera to wireless flash mode when using an external flash in
combination with the built-in flash.
1
Remove the external flash unit after the channel is set on
the camera, and place it at the desired location.
2
Press the four-way controller (3).
The [Flash Mode] screen appears.
3
Select r and press the 4
button.
The camera is ready to take a picture.
The channel for the built-in flash is
displayed in the viewfinder and on the
LCD panel. The factory default setting is
CH1.
4
Press the E button.
5
Confirm that both flashes are fully charged, and then take
a picture.
Wireless Shooting Using a Combination of the Built-in
Flash and an External Flash Unit
• r cannot be set when the exposure mode is set to B (Green).
• When the drive mode is set to i (Remote Control (3s delay)), d (Mirror
Lock-up) or e (Mirror Lock-up + Remote Control), or the lens aperture is not
set to the s position, r cannot be selected.
Flash Mode
Wireless Mode
Cancel OK
OK
MENU
0.0