Filter
Top Products
314
Appendix
11
Autofocus
does not work
The focus mode is
set to \
Set the focus mode switch to l or A.
(p.108)
The focus
cannot be
locked
The focus mode is
set to k
Autofocus is not locked (focus lock) when
the focus mode is set to k (A). The
camera will continue focusing on the subject
while the shutter release button is pressed
halfway. If there is a subject that you wish to
focus on, slide the focus mode switch to
l and use the focus lock. (p.108)
The AE Lock
function does
not operate
The exposure
mode is set to B,
p or M mode
Set the exposure mode to any mode other
than B (Green), p (Bulb Exposure) or M
(Flash X-sync Speed).
The built-in
flash does not
discharge
The exposure
mode is set to B
mode
Only C (Auto Flash Discharge) and D
(Auto Flash+Red-eye Reduction) are
available for the flash mode when the
exposure mode is B (Green). The flash will
not discharge when the subject is bright in
these modes. In the exposure modes other
than B, only the flash mode that
discharges every time the flash recharges is
available. Try different exposure modes.
The USB
connection with
a computer
does not work
properly
The USB
connection mode is
set to [PTP]
Set [USB Connection] to [MSC] in the [R
Set-up 2] menu. (p.279)
Shake
Reduction
does not work
The Shake
Reduction function
is off
Set [Shake Reduction] to k (On) in the
[A Rec. Mode 4] menu. (p.122)
The Shake
Reduction function
is not set properly
If a lens for which the focal length
information cannot be obtained is used, set
the focal length in the [Input Focal Length]
screen. (p.124)
Shutter speed is too
low for the Shake
Reduction function
to be effective when
panning or shooting
night scenes, etc.
Turn off the Shake Reduction function and
use a tripod.
The subject is too
close
Move away from the subject, or turn off the
Shake Reduction function and use a tripod.
Problem Cause Remedy