Filter
Top Products
When the camera is fully opened, the interlock
switch (S6), located at the left rear corner of
the mirror cover, is closed and the battery is
connected to the camera electrical circuit.
(Figure 1-4).
The front coverlatchis located on the right side
of the camera just inside the rim of the bottom
cover assembly. Pressing down on this yellow
latch releases the front cover which drops down
to expose the lm chamber. With the cover open,
a lm pack can be inserted or an exhausted pack
can be removed.
A fresh lm pack is loaded into the lm chamber
observing color coding (Figure 1-5). Under
certain circunstances a partially used pack could
be inserted, but this action will cause some
deviation in the normal counting sequence.
The battery is a part of each lm pack, and the
two exposed terminals on the pack engage two
contacts within the lm chamber as the pack is
inserted.
With the lm pack in place, the front cover can
be closed. It must be fully closed and latched.
2. Loading the Film pack
3. Starting the Automatic Mechanism
Figure 1-5 Inserting lm pack
Figure 1-4 S6 with contacts closed