Filter
Top Products
120
Using the Remote Control
This section explains how to operate the camera using the optional remote
control units, DR-3 and DR-4 (available in the near future).
Important
Note
•
The remote control receiver is located on the front of the camera. Operate
the remote control unit by pointing it at the remote control receiver.
Note
• For instructions on replacing the batteries and maintaining the remote
control unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit
and on the camera itself. Follow the instructions below to use the
remote control unit.
Using the DR-4 Remote Control
A Set the mode dial on the camera to a
recording mode ( , , or ) and
press the button to select the
recording destination.
B Decide the composition of the picture
and press the RELEASE button on
the remote control unit.
Press to make the subject larger, and
press
to make the subject smaller.
● In
(Still Picture) mode
The self-timer LED will light and recording
will start after about 2 seconds.
● In
(Text) mode
Recording starts as soon as the RELEASE
button is pressed.
● In
(Voice Memo) or (Motion Picture) mode
Recording of the image and/or voice memo
starts when the RELEASE button is pressed.
Recording stops when the button is pressed
again.