Ricoh CAMERA RDC-i500 Digital Camera User Manual


 
128
Troubleshooting
Refer to the pointers listed below before submitting the equipment for repairs. If
the problem persists after trying the suggestions, contact your nearest Ricoh
service office.
Power Source
Problem
Power will not
come on
Power cuts out
Battery will not
charge
Battery quickly
consumed
Cause
Battery not loaded or battery
exhausted
AC adapter not properly connected
No operation performed so auto
power off function was activated
Battery exhausted
Battery at end of service life
Camera operated in extremely high
or low temperature environment
Camera operated in dark
environment requiring frequent use
of flash
Remedy
Insert battery correctly or charge battery.
Connect correctly.
Switch camera on again.
Charge battery.
Replace with new battery.
Page
P.15
P.16
P.18
P.24
P.15
P.16
Recording and Playback
Problem
Cannot confirm
shot image
No image on
LCD monitor
Cause
Battery not loaded or battery
exhausted
No power, or mode dial not set to
recording mode.
Shutter release button not fully
pressed (pressed halfway)
Card not formatted
No memory space on card
No space in internal memory
Card at end of service life
Self-timer on
Flash charging
Card card contact surface dirty
LCD confirmation time too short
No power or LCD monitor is dark
Remedy
Insert battery correctly or charge battery.
Switch on and set mode dial to recording
mode.
Press shutter release button all the way.
Format card.
Delete unnecessary files or insert new card.
Delete unnecessary files.
Insert new card.
Disengage self-timer mode.
Wait until flash LED stops blinking.
Clean with soft dry cloth.
Increase LCD confirmation time.
Switch on and press DISPLAY button to
display image on LCD monitor or press
DISPLAY button 2 seconds or more and
adjust with
· buttons.
Page
P.15
P.16
P.24
P.25
P.47
P.35
P.20
P.103
P.103
P.20
P.62
P.48
P.109
P.41
P.37
Shutter release
button pressed
but no file
recorded