Filter
Top Products
English - 8
Installing Batteries in the Remote Control
Normal Remote Control
1.
Lift the cover at the back of the remote control upward as shown in the gure.
2. Install two AAA size batteries.
Make sure to match the “+” and “–” ends of the batteries with the diagram inside the
compartment.
3.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be using the
remote control for a long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries should last for about one year.)
Using the remote control with the
TV
SET RESET
VCR DVD STB
ON/OFF light button set to On will reduce the
battery usage time.
Mini Remote Control
1.
Turn the battery cover counterclockwise to unlock it and then separate the battery cover.
2. Insert the corresponding 3V Lithium battery.
3. Place the battery cover into the remote control aligning it with the grooves and then turn the
battery cover clockwise to lock the cover.
If the remote control doesn’t work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage or is the power cord unplugged?
5. Is there a special uorescent light or neon sign nearby?
➣
➣
➣
➣
Mini Remote Control
The Mini Remote Control is a simplied remote control that consists of the power, channel
and volume buttons only.
1
Television Standby button
This button only works when you press it for longer than 1.5 seconds.
2
: Next channel
: Previous channel
3
+ : Volume increase
– : Volume decrease
4
IrDA transmitter
Use the Mini Remote Control so that this part faces the TV.
➣
➣
1
4
3 3
2
2
BN68-01691A-00Eng.indb 8 2008-07-18 �� 10:24:04