Filter
Top Products
English - 23
Setting Up the Remote to Operate Your STB
1.
Turn off your STB.
2. Press the MODE button and make sure that the STB LED is illuminated.
3. Press the SET button on your TV’s remote control.
4.
Using the number buttons on your remote control, enter three digits of the STB
code listed on page 26 of this manual for your brand of STB.
Make sure you enter three digits of the code, even if the rst digit is a “0”.
(If there is more than one code listed, try the rst one.)
5. Press the POWER button on the remote control.
Your STB should turn on if your remote is set up correctly.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4, but try one of
the other codes listed for your brand of STB.
(If no other codes are listed, try each code, 000 through 074.)
Note on Using Remote Control Modes: STB
When your remote control is in STB mode, the volume buttons still control your
TV’s volume.
Setting Up the Remote to Operate Your Cable Box
1.
Turn off your Cable Box.
2. Press the MODE button and make sure that the STB LED is illuminated.
3. Press the SET button on your TV’s remote control.
4.
Using the number buttons on your remote control, enter three digits of the cable
box code listed on page 26 of this manual for your brand of cable box. Make sure
you enter three digits of the code, even if the rst digit is a “0”. (If there is more
than one code listed, try the rst one.)
5. Press the POWER button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3 and 4, but try one
of the other codes listed for your brand of cable box. If no other codes are listed,
try each code, 000 through 046.
Note on Using Remote Control Modes: STB
When your remote control is in STB mode, the volume buttons still control your
TV’s volume.
➣
➣
TV
SET RESET
VCR DVD STB
TV
SET RESET
VCR DVD STB
TV
SET RESET
VCR DVD STB
TV
SET RESET
VCR DVD STB
BN68-01691A-00Eng.indb 23 2008-07-18 �� 10:24:20