Filter
Top Products
Chapter 4 Adjustments and Settings for Recording4-42
4
When changing the setup menu
You can configure the setup menu to display only the pages you need.
To select pages, use the MENU SELECT page of the engineer-oriented
menu. When using the engineer-oriented menu, switch the camcorder to
engineer mode. Power off the camcorder, then hold down the rotary
encoder and turn the power on again.
To revert to the user mode, turn the camcorder off and then on.
Engineer mode and user mode differ in the following ways.
Engineer mode: All the pages in the setup menu can be used. Data set
with the menu is written to non-volatile memory and can be stored
semi-permanently.
User mode: Only the pages selected in the engineer mode MENU
SELECT page can be used. Data set with the menu is written to
non-volatile memory and can be stored semi-permanently.
After making settings and adjustments in engineer mode, configure the
CAMERAMAN menu on the MENU SELECT page with the pages you
use frequently so that you can access them quickly.
Refer to “maintenance manual” for information about the MENU SELECT page.
For information about the CAMERAMAN menu settings, see section 4-9-7 “Setting
the CAMERAMAN menu” (page 4-95).