Filter
Top Products
Chapter 6 Maintenance 6-7
6
6 Press the VTR START button again, and check that the tape stops
and that the REC indicator in the viewfinder goes off.
7 Repeat the checks of steps 5 and 6, this time using the VTR button
on the lens.
8 Press the RESET button, and check that the counter display goes to
“00 : 00 : 00 : 00”.
9 Turn on the LCD LIGHT switch, and check that the display panel is
illuminated.
10Hold down the REW button to rewind the tape for a while, then
press the PLAY button. Check that the rewind and playback
functions operate normally.
11Press the STOP button and press the F FWD button. Check that the
fast forward function operates normally.
2 Testing the automatic audio level adjusting
functions
1 Set the AUDIO SELECT CH-1/CH-2 switches to AUTO.
2 Set the AUDIO IN switches to FRONT.
3 Aim the microphone connected to the MIC IN connector at a
suitable sound source. Check that the level indications for both
channels correspond to the sound level.
3 Testing the manual audio level adjusting functions
1 Set the AUDIO IN switches to FRONT.