Filter
Top Products
Chapter 4 Adjustments and Settings for Recording4-120
4
2 • To enable the write-protection function (the “ON” setting), turn
the rotary encoder counterclockwise as seen from the front of the
camera.
• To disable the write-protection function (the “OFF” setting), turn
the rotary encoder clockwise.
If data cannot be written
If when you press the rotary encoder in step 6 of the foregoing procedure
(page 4-116) one of the following error messages appears, then the data
was not written.
Data write error messages
Error message Reason Action
CARD NOT
INSERTED!
No setup card is
inserted.
Close the menu and insert or
reinsert the card.
WRITE
PROTECTED!
WRITE PROTECT
is set to ON.
Set WRITE PROTECT to OFF.
WRITE ERROR!
(flashing)
Circuit or card fault Check the circuitry, or replace the
card with a verified card.
Reading saved data from a card
Follow the procedure below.
Reading saved data from a card
1,2,7
4,6
3,5