Filter
Top Products
Chapter 4 Adjustments and Settings for Recording 4-91
4
4-9-5 Setting the color temperature manually
You can adjust the value of the white balance manually by setting the
color temperature.
This setting is done in engineer mode. To change the camcorder to
engineer mode, turn the power off, then turn it on again while pressing
down the rotary encoder.
To do this setting in user mode, go to MENU SELECT 4 in engineer
mode or store this item in the CAMERAMAN menu.
For more details on this setting, refer to “maintenance manual.”
For information about the CAMERAMAN menu settings, see section 4-9-7 “Setting
the CAMERAMAN menu” (page 4-95).
1 Set the camcorder to the engineer mode and turn the MENU ON/
OFF/PAGE switch to ON.
3
1,2
5
4
(Continued)