Filter
Top Products
Chapter 6 Maintenance6-4
6
(4) Turn the rotary encoder and check that the setting value or ON/
OFF indication of the item selected by the cursor changes.
4 After once setting the MENU ON/OFF/PAGE switch to OFF, set the
OUTPUT/DCC selector to CAM, and change the ND FILTER
selector position in the sequence of 1, 2, 3, 4. Check that the
FILTER indicator on the viewfinder screen displays the correct
numbers.
5 Check each of the following operations, and make sure that the
indicator lights if the corresponding item has been turned on in the
‘!’ LED page.
(1) Set the gain to anything but 0 dB by the GAIN selector and on
the MASTER GAIN page of the setup menu.
(2) Set the SHUTTER selector to ON.
(3) Set the WHITE BAL switch to PRST.
(4) Use the lens extender.
(5) Set the ND FILTER selector to anything but 1.
(6) Set the iris to automatic mode, and turn the rotary encoder to
change the reference value to other than the standard value.
6 Push the SHUTTER selector from ON to SEL repeatedly, and check
that the shutter setting changes on the viewfinder screen.
7 Pointing the camera at a suitable subject, focus the camera and
check the picture on the viewfinder screen.
8 (1) Set both of the AUDIO IN switches to FRONT and the
DISPLAY switch on the viewfinder to ON. Check that when
sound is input to a microphone connected to the MIC IN
connector on the front of the camcorder, the audio level
indication appears on the viewfinder screen.