Filter
Top Products
203
Additional Information
Maintenance information
Cleaning the video heads
To ensure normal recording and clear pictures, clean the video heads. The video heads
may be dirty when:
•Mosaic-pattern noise appears on the playback picture.
•Playback pictures do not move.
•Playback pictures do not appear.
•The x indicator and “ CLEANING CASSETTE” message appear one after another
or the x indicator flashes on the screen.
If the above problem [a], [b] or [c] occurs, clean the video heads for 10 seconds with the
Sony DVM-12CLD cleaning cassette (optional). Check the picture and if the above
problem persists, repeat cleaning.
If the video heads get dirtier, the entire screen becomes blue [c].
Note on the videohead
The videohead suffers from wear after long use. If you cannot obtain a clear image even
after using a cleaning cassette, it might be because the videohead is worn. Please contact
your Sony dealer or local authorized Sony service facility to have the videohead
replaced.
Cleaning the LCD screen
If fingerprints or dust make the LCD screen dirty, we recommend using the LCD
Cleaning Kit (optional) to clean the LCD screen.
Charging the built-in rechargeable battery in your camcorder
The built-in rechargeable battry is installed in your camcorder to retain the date and
time, etc., regardless of the setting of the POWER switch. The built-in rechargeable
battery is always charged as long as you are using your camcorder. The battery,
however, will become discharged gradually if you do not use your camcorder. It will be
completely discharged in about four months if you do not use your camcorder at all.
Even if the built-in rechargeable battery is not charged, it will not affect camcorder
operation. To retain the date, time, and other information, charge the battery if the
battery is discharged.
Charging the built-in rechargeable battery:
•Connect your camcorder to wall outlet using the AC power adaptor supplied with
your camcorder, and leave your camcorder with the POWER switch turned off for
more than 24 hours.
•Or, install a fully charged battery pack in your camcorder, and leave your camcorder
with the POWER switch turned off for more than 24 hours.
Maintenance information and precautions
[a]
[b]
[c]