Filter
Top Products
24
Preparing the Power Supply
Chapter 2 Installation and Preparations
Attaching a viewfinder
When the supplied center handle is attached to the top of
the camera head, you can attach the viewfinder to the
viewfinder shoe of the center handle after removing the
viewfinder shoe from the camera head.
The procedure for attaching the viewfinder is the same as
when attaching it to the viewfinder shoe of the camera head
(see page 21).
2-7 Preparing the Power
Supply
This camera operates on DC 12 V (10.5 to 17 V).
Supplying power directly to the camera
head
Connect a power supply to the DC IN connector of the
camera head.
Use a commercially available shielded cable by attaching
the supplied 8-pin connector for a power cable.
For details on the connection, consult your local Sony
representative.
To turn on the camera
Set the CAM POWER switch of the camera head to the ON
side, and the camera is turned on.
Power is also supplied to the viewfinder and lens mounted
on the camera head.
Power of 12 V or 24 V can be fed to accessories via the DC
OUT connectors.
Supplying power via the interface box
To supply power via the interface box, mount the interface
box to the rear of the camera head. If the interface box is
mounted on the top, the power is not fed to the camera
head.
Connect a power supply to the DC IN connector (XLR 4-
pin) of the interface box.
To turn on the camera
Set the CAM POWER switch of the camera head to the CA
side, and the camera is turned on.
The power is also supplied to the viewfinder and lens
mounted on the camera head.
To use an AC power source
An AC power source can be connected, by using the AC-
DN2B AC Adaptor.
1
Attach the AC-DN2B to the interface box.
2
Connect the DC power cord supplied with the AC-
DN2B to the DC IN connector of the interface box.
3
Connect the AC-DN2B to an AC power source.
To use a battery pack
The BP-GL95 Lithium-ion Battery Pack can be used.
By attaching the BKP-L551 Battery Adaptor to the
interface box, connect the BP-GL95 Lithium-ion Battery