Filter
Top Products
40
Setting the Camera Outputs
Chapter 3 Basic Adjustments and Settings
Timing of the pulse signal
Example 1: SHUTTER OFF
Example 2: SHUTTER ON, shutter angle 180º
RM VIDEO
The video signals to be output to equipment connected via
the REMOTE connector can be selected.
3-5-2 Setting the Monitor Picture
Using the <PB/MONI GAMMA> page of the USER
(OPERATION) menu displayed on the viewfinder screen,
the gamma setting of the monitor picture and the playback-
picture monitor mode can be selected.
<PB/MONI GAMMA> page
To apply monitor gamma to the monitor
picture
MONI GAMMA ENABLE
If this is set to ON, the monitor gamma (ITU-R709)
appropriate for monitoring
1)
is applied to the video signals
output from the VF1, VF2, MONITOR OUT HD SDI 1/2,
or REMOTE connector. The video output signals from
those connectors are selected on the <MONITOR
OUTPUT> page.
This setting is effective when S-LOG gamma is applied to
the video output signals for recording intended for post-
production editing.
1) The VBS output signal always becomes the camera image to which ITU-
R709 gamma is applied.
• If the monitor gamma is activated with 23.98PsF/
S23.98PsF, the output for viewfinders and monitors is
switched to 59.94i. In the case of 24PsF/S24PsF, the
output is switched to 50i. To eliminate this phenomena,
change the DOWN CONVERTER setting on the
<POWER SAVE> page of the MAINTENANCE menu
from ACTIVE to PWR SAVE.
• Some of the paint settings (such as black gamma, knee,
detail, matrix, etc.) for the main line are not applied to
monitor gamma.
To monitor the playback picture
The playback picture of the recorder can be confirmed with
a monitor connected to the camera or on the viewfinder
screen.
2)
2) When MONI GAMMA ENABLE is set to OFF, the same gamma as that
applied to the main line is applied to all the outputs. However, the PB and
PB MIX modes can be independently selected for the VF, MONI, and VBS
signals.
PB
The playback-signal output mode can be selected for each
VF, MONI, or VBS signal.
If the recorder is turned off with PB ON, the picture on the
viewfinder/monitor screen is distorted. The normal picture
is restored by turning the recorder on or setting PB to
AUTO or OFF.
Setting Signal
VBS The VBS signals are output. (Default)
VF2 The HD-Y signals are output.
REF-THRU The reference signal that is input to the
GENLOCK IN connector is output as-is.
FRAME A pulse is output per frame (in a case of
1 FPS, one pulse per second).
Setting Signal
VBS The VBS signals are output. (Default)
VF2 The HD-Y signals are output.
CCD exposure
Frame pulse
1 frame
ExposureExposure
CCD exposure
Frame pulse
1 frame
Exposure
Exposure
<PB/MONI GAMMA> 08
MONI GAMMA ENABLE: OFF
VF MONI VBS
PB :
B
OFF OFF OFF
PB MIX: OFF OFF OFF
MONITOR GAMMA
VF : OFF
MONI : OFF
VBS : R709
GAMMA MARK SETTING
Notes
Setting Signal
ON The playback picture of the recorder is always
output.
AUTO Normally, the camera image is output. When
the recorder enters playback mode (PLAY, FF,
REW, or REC REVIEW,) the playback picture
is automatically selected.
OFF The camera image is always output. (Default)
Note