Sony HD-RCX300 Camcorder Accessories User Manual

Getting started
You can charge the “InfoLITHIUM” battery pack (V series) after attaching it to your
You cannot attach any “InfoLITHIUM” battery pack other than the V series to your camcorder.
Turn off your camcorder by closing the LCD screen.
Attach the battery pack by aligning the battery terminals () and
pushing the battery pack in the direction of the arrow () until it clicks.
Connect the AC Adaptor and the power cord (mains lead) to your
camcorder and the wall outlet (wall socket).
Align the mark on the DC plug with that on the DC IN jack.
The /CHG (flash/charge) lamp lights up and charging starts. The /CHG (flash/charge)
lamp turns off when the battery pack is fully charged.
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
See page 96 on recording and playing time.
When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper left on the LCD screen.
Charging time
Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack Charging time
NP-FV50(supplied) 155
NP-FV70 195
NP-FV100 390
Times measured with the camcorder at 25 C (77 °F).
C to 30 C (50 °F to 86 °F) is recommended.
To remove the battery pack
Close the LCD screen. Pushing the PUSH (battery release) button (), remove the battery
pack in the direction of the arrow ().