Filter
Top Products
28
Enable Sabotage Detection
The Camera Sabotage Detection feature will notify users that the field of vision of a camera has been compromised, abruptly changed, or
detects significant vibration.
To enable Sabotage Detection:
1. In the Motion Detection window, click the Sabotage Detection tab.
2. Select Enable Sabotage Detection.
3. Set the Pixel Change threshold to reduce false alarms
4. To activate an alarm relay on Sabotage Detection, click Activate Relay, and the select the appropriate relay number.
5. Select the Beep on Detect check box to enable the recorder to emit an audible beep on Sabotage Detection.
6. Click Apply to save your settings.
Etc.
Additional motion detection configuration options are found on the Etc. tab. Use this tab to set a camera channel to appear at full screen
in the Display screen when a motion or sensor event is detected. You can also set your recorder to enable motion detection even during
continuous recording, or play an audio warning when an alarm event is detected.
Note It is not recommended to enable Full Screen Pop Up on Motion for all channels (either manually, or by clicking Apply to All
Channels). This will cause performance problems.
Set a camera channel to be
immediately displayed full
screen
Enable motion detection
during continuous recording
Enable an audio warning
during an alarm event
Set to record a single image at a
specified interval (1 sec ~ 24 hr)