Filter
Top Products
32338AC 39
Alarm Options
Use the Alarm Options section to configure the alarm output for specific events.
There are two Alarm Options
Sensor Event – Trigger an alarm output based on a sensor
Motion Event – Trigger an alarm output based on motion detection
Motion can be designated as an alarm event. Often motion does not need to be treated as an Alarm event. For example: During work
hours, motion that occurs is expected and should not be treated as an alarm. However, after business hours, any motion that occurs
could be treated as an alarm.
1. In the Display screen, click Setup.
2. Click Recording Schedule.
3. In the Alarm Options section, select Sensor Event, Motion Event, or both.
4. Once you have selected an Event option, you can select alarm options.
Map Alarm –Enable this camera to work the the Map Alarm function of SCS remote monitoring software.
Emergency Alarm – Send video to a PC running Emergency Agent software.
5. Set the Transmission Duration (in seconds) for this alarm.
6. Enter up to five Emergency IP of PCs running Emergency Agent software.
Note If you type a URLrather than an IP address in this field, all of the text may not be visible once it is entered. To view the entire URL,
hover your mouse pointer over your desired URL.
7. Select the appropriate Emergency IP addresses. You can only use one IP address at a time.
8. Click Apply to save your settings.
Tip See the Emergency Agent chapter for detailed information on setting up the Emergency Agent software.