Advanced Configuration and Management Guide
Table 10.7: BGP4 Route Summary Information for a Neighbor (Continued)
Routes Advertised The number of routes the routing switch has advertised to this
neighbor.
• To be Sent – The number of routes the routing switch has queued
to send to this neighbor.
• To be Withdrawn – The number of NLRIs for withdrawing routes
the routing switch has queued up to send to this neighbor in
UPDATE messages.
NLRIs Sent in Update Message The number of NLRIs for new routes the routing switch has sent to
this neighbor in UPDATE messages.
• Withdraws – The number of routes the routing switch has sent to
the neighbor to withdraw.
• Replacements – The number of routes the routing switch has
sent to the neighbor to replace routes the neighbor already has.
Peer Out of Memory Count for Statistics for the times the routing switch has run out of BGP4 memory
for the neighbor during the current BGP4 session.
• Receiving Update Messages – The number of times UPDATE
messages were discarded because there was no memory for
attribute entries.
• Accepting Routes(NLRI) – The number of NLRIs discarded
because there was no memory for NLRI entries. This count is not
included in the Receiving Update Messages count.
• Attributes – The number of times there was no memory for BGP4
attribute entries.
• Outbound Routes(RIB-out) – The number of times there was no
memory to place a “best” route into the neighbor's route
information base (Adj-RIB-Out) for routes to be advertised.
This Field... Displays...
Displaying Advertised Routes
To display the routes the routing switch has advertised to a specific neighbor for a specific network, enter a
command such as the following at any level of the CLI:
HP 9304M or HP 9308M# show ip bgp neighbors 192.168.4.211 advertised-routes
There are 2 routes advertised to neighbor 192.168.4.211
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Network ML Next Hop Metric LocPrf Weight Status
1 102.0.0.0 24 192.168.2.102 12 32768 BL
2 200.1.1.0 24 192.168.2.102 0 32768 BL
You also can enter a specific route, as in the following example:
HP 9304M or HP 9308M# show ip bgp neighbors 192.168.4.211 advertised 200.1.1.0/24
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Network ML Next Hop Metric LocPrf Weight Status
1 200.1.1.0 24 192.168.2.102 0 32768 BL
Syntax: show ip bgp neighbor <ip-addr> advertised-routes [<ip-addr>/<prefix>]
For information about the fields in this display, see Table 10.9 on page 10-105. The fields in this display also
appear in the show ip bgp display.
10 - 100
