A SERVICE OF

logo

Advanced Configuration and Management Guide
Actions
An IP/RIP neighbor filter applied to outbound traffic on a port permits or denies advertisement of routes.
An IP/RIP neighbor filter applied to inbound traffic on a port permits or denies learning of the routes
advertised by the neighbor. When the device learns an IP/RIP route, the route is added to the IP/RIP route
table.
Scope
You configure IP/RIP neighbor filters globally. They are automatically applied to all RIP ports as soon as you
configure them.
Syntax
Use the following CLI commands or Web management interface panels to configure IP/RIP neighbor filters.
Table C.14: IP/RIP Neighbor Filters
CLI syntax Web management links
HP9300(config-rip-router)# neighbor <filter-num> permit | deny
<source-IP-address> | any
Configure->RIP->Neighbor Filter
C - 18
Neighbor
RIP Router
Inbound IP/RIP Neighbor Filter for Port 4/3
FilterID Action Source
--------------------------------------------------------
1 Deny 192.99.26.1/24
1024 Permit any
201.44.67.1/24
X
Neighbor
RIP Router
192.99.26.1/24